Largest Manufacturing Technology Community on the Web
Stay Connected:
jbacc's latest activity
-
Jjbacc replied to the thread OT- bait for mouse traps?.I have used varying size pieces of hot dogs depending on the size of the trap as bait. Pretty effective at attracting mice and rats.
-
JAre you certain you need 20° PA? Have a huge collection of 14.5 pa gear cutters here. Just checking
-
Jjbacc reacted to wood2steel's post in the thread Can anyone tell me what happened to this jumper cable? with
Like.
We've had entrance power cables replaced on several dozen Remodel projects over the years from squirrels chewing into the insulation... -
Jjbacc replied to the thread Can anyone tell me what happened to this jumper cable?.^^^^^^^^^^ My vote is rodent damage to the insulation which opened the door for the cable to corrode.
-
Jjbacc reacted to reggie_obe's post in the thread Can anyone tell me what happened to this jumper cable? with Like.
Rodent damage on the insulation?
-
JI've been making steady progress on the motor. The bearings are cleaning up great with an overnight soak in zep purple degreaser. I got...
-
JYou are going about it the wrong way. The soil is the most important. Are you building a new slab in a existing building or is this a...
-
Jjbacc replied to the thread Table saw - single phase motor burnt out.In my humble and non-expert opinion, the windings look like toast. I would be looking to have a motor shop rewind it or find a replacement.
-
JThose parts are made the same at the factory, look on eBay and buy a new used one. Or bolt on the plate and use it until you can find...
-
JWould not be putting enough heat into that casting to braze repair that broken section. Think your idea of inserting a steel plate and...
-
Jjbacc reacted to Dahoud62's post in the thread Against my better judgment I purchased this at an auction anyone have any idea what it is Fowler Angst with Like.
I still can't post catalog info. My images are too large Depending on the model: Straightness accuracy is either 0.00002" or 0.00004"...
-
JCan you make a round boss for the eccentric bore and just clamp the swingarm to it?
-
Jjbacc reacted to dcsipo's post in the thread Bench grinder mounted diamond blade sharpener with Like.
Just use a motor and controller from a treadmill.
-
Jjbacc reacted to michiganbuck's post in the thread Mill bits last 200 pieces one day and 20 the next with Like.
Guess I would quickly eyeball inspect the cutters with a loupe to see the cutting edge and that the back off comes right up to the edge...
-
JIf it is a ball way long travel machine and you are capable it would not hurt to clean the balls I like to put the balls in the same...