Largest Manufacturing Technology Community on the Web
Stay Connected:
texasgeartrain's latest activity
-
texasgeartrain replied to the thread Monarch 12CKK, Prepping to Get Back in Service.Moving on for a quick once over. Bed ways amazingly nice for a 1946 machine. Guessing the lube system worked here, or the operator... -
-
texasgeartrain replied to the thread Monarch 12CKK, Prepping to Get Back in Service.Now for a little bad news and a rant, lol. In post #3 we see clutch rod off of qcgb due to broke coupling. I knew that. In special...
-
-
texasgeartrain reacted to Peroni's post in the thread Monarch 12CKK, Prepping to Get Back in Service with
Like.
I've found HGR's search engine can do funky things at times like not recognizing the name or showing zero results when there are in fact... -
"Bring enough gun"...
-
texasgeartrain replied to the thread Round Dial 10EE Compound Holes.I don't know your's exactly, but in compound rests they would be for shooting some oil in on occasion. The handle side not only is a...
-
She was born and raised right here in Ohio.
-
texasgeartrain reacted to m-lud's post in the thread Monarch 12CKK, Prepping to Get Back in Service with Like.
Another nice piece of iron! It has that nice look of not being hammered on. Paint worn off in normal places but not covered in pecker...
-
texasgeartrain replied to the thread Monarch 12CKK, Prepping to Get Back in Service.Funny you mention that :D. I had this convo with tailstock4. Not sure now, but when I searched Pratt & Whitney on their site, zero...
-
-
texasgeartrain reacted to Rob F.'s post in the thread How will China's new airliner fair? with Like.
Its kind of sad how people still associate cheap consumer goods with chinas ability to make quality stuff. The corporate buyers for...
-
texasgeartrain reacted to swells's post in the thread Yet another 13" Taper Attachment Thread with Like.
This copy is a little hard to see the photos, but it's the only one I have. Form 1072, Fitting the Taper Attachment - 10–16-inch lathes...
-
texasgeartrain replied to the thread How will China's new airliner fair?.I couldn't speak for aircraft design. But I've been on Chinese airlines inside of China. Very reminiscent of US airplanes and service of...
-
texasgeartrain replied to the thread Yet another 13" Taper Attachment Thread.The holes for pins must be drilled all the way through TA mounting. No way someone laid out, marked, and drilled blind holes in both...
-
texasgeartrain reacted to Ultradog MN's post in the thread Monarch 12CKK, Prepping to Get Back in Service with Like.
Cool! My friend's CKK is very similar - kind of a plain Jane so far as options and doo dads go. His is also 5 hp. Has 1K spindle speed...
-
texasgeartrain replied to the thread Monarch 12CKK, Prepping to Get Back in Service.I didn't pop anything into TS taper yet, but an eyeball measure looks like MT4. I love the original start/stop/reverse switch. I'll be...
-
-
texasgeartrain replied to the thread Yet another 13" Taper Attachment Thread.As you said, with alignment and such done, and with TA mounting bolted tightly to saddle. Drill right through existing holes of TA...
