Largest Manufacturing Technology Community on the Web
Stay Connected:
sfriedberg's latest activity
-
sfriedberg replied to the thread What is premium Bed Sheets?.Frigging STUPID spammer reported -
I've put it on a couple of lasers, a desktop computer, and a press brake with good success so far.
-
sfriedberg replied to the thread First year for USB on machines.If that is a faithful HW emulator, great.
-
sfriedberg replied to the thread New to me Van Norman 26.Releading was cheaper than buying a new motor. I think I paid somewhere between $100 and $200. For a one-time refurb, I didn't flinch...
-
sfriedberg replied to the thread First year for USB on machines.Don't. Floppy disks aren't being made any more, and there're just a few distributors of the old stock that is already aging on the...
-
sfriedberg replied to the thread New to me Van Norman 26.On a slight tangent, the motor on my VN is so old (1956), it's from the earlier NEMA frame series. I decided to have a local motor shop...
-
sfriedberg reacted to mrplasma's post in the thread Repurposed old Troyke rotary table as welding positioner with
Like.
Three clamping shaft collars and some scrap steel bar make a sturdy fully adjustable hand rest. It can also accommodate a Tweco torch... -
sfriedberg replied to the thread New to me Van Norman 26.My VN is a #28A, with a totally different location for the feed motor, mounted to the right side of the knee. Can't help with that...
-
sfriedberg reacted to GEORGIE's post in the thread What type is this split lead screw nut? with Like.
peterbilt wallpaper
-
sfriedberg replied to the thread New Shop Concrete Thickness.Both of these points have already been made, but it's worth repeating. 1) Get the foundation specs from the machine tool maker. It may...
-
You are going about it the wrong way. The soil is the most important. Are you building a new slab in a existing building or is this a...
-
sfriedberg replied to the thread Building full of machinery. Where do I sell?.The simplest solution to get it all moved out is hire an auctioneer, preferably one that specializes in factory and machine shop...
-
sfriedberg replied to the thread Time for overhaul on my 10EE - Looking for someone in the PNW to help, no lifting required!.Please pin down your location a bit more. Are you a 10hr drive, a 6 hr drive, or a 30minute drive from, say, Portland, OR, or Seattle...
-
This is what the OP is looking at. There is about .020 clearance for the punch, and the punch was never meant to push material down that...
-
sfriedberg replied to the thread Video of large planer mill with pushbrooms on fire.Yep, pretty sure that's it. I had (mis)remembered it as being taken from a higher vantage point, so there might have been a 2nd camera...