Largest Manufacturing Technology Community on the Web
Stay Connected:
DouglasJRizzo's latest activity
-
DouglasJRizzo replied to the thread Mastercam popularity.True on all counts. -
DouglasJRizzo replied to the thread OT- bait for mouse traps?.My dad used a mouse trap that looked like a fiberglass box. You wound it up and it guillotined the mouse when it went in.
-
Another vote for peanut butter, and trap placement. Butt the end of the trap up against the wall, as that is where they travel. The...
-
DouglasJRizzo replied to the thread Mastercam popularity.The GibbsCam I had was closer to $50k with everything.
-
DouglasJRizzo replied to the thread Doosan MV3016 use pneumatic or hydraulic activated tool clamping ?.That model was out of production when I worked there, but I can tell you that the DNM uses a servo driven ATC arm. The drawbars are...
-
DouglasJRizzo replied to the thread Mastercam popularity.It's "Big Daddy" for a few reasons. Its interface is pretty straight forward, and its pricing was a bit more reasonable than many of the...
-
DouglasJRizzo reacted to Garwood's post in the thread Looking for 7" dia thick wall steel tube for bearing housing with
Like.
Usually significantly cheaper to use solid bar. -
DouglasJRizzo reacted to EmanuelGoldstein's post in the thread Looking for 7" dia thick wall steel tube for bearing housing with Like.
For two whole feet ? You ain't kiddin. Plus tubing is frequently really nasty to work with.
-
DouglasJRizzo reacted to ducesrwld's post in the thread Ellison Rant.......can't deliver on getting a new lathe up and running. with Like.
see how the other side of the table enjoys a month delay in that next payment!....takes 2 to tango
-
Both of these points have already been made, but it's worth repeating. 1) Get the foundation specs from the machine tool maker. It may...
-
You are going about it the wrong way. The soil is the most important. Are you building a new slab in a existing building or is this a...
-
DouglasJRizzo replied to the thread turret indexing adjustment?.The turret itself is slightly off radially. It will need to be re-aligned. Not difficult to do, any service person could do it. You may...
-
DouglasJRizzo replied to the thread Groove/part tool recommendations.I've used Manchester as well as Kennametal with excellent results.
-
DouglasJRizzo replied to the thread Need help to connect Doosan 2100A over network.PM me, I have a booklet that i wrote up when I worked for Doosan. It's not too bad a job..
-
DouglasJRizzo reacted to bosmos_j's post in the thread Need help to connect Doosan 2100A over network with Like.
Ellison gave me instructions for ethernet connection from 2010. It doesn't have my control so it didn't work. Various futzing around...