apiazza2010
Plastic
- Joined
- Aug 16, 2022
Hello All,
Thank you again for all the help in this forum.
I was wondering if anyone is aware on how to setup a taper on a custom thread turning toolpath in MasterCam.
They are "looking into it" but I'm wondering if this is just a limitation of the software. In FeatureCAM guides it mentions that I can use the thread chain, and the software will use the difference between X values at the start and end of the chain for the taper
Is this something that can be done in MC?
I'm manufacturing an auger for concrete using a standard lathe. I was able to make one with straight threads really well using a 08 button tool, but i'm struggling with this.
Thank you
Thank you again for all the help in this forum.
I was wondering if anyone is aware on how to setup a taper on a custom thread turning toolpath in MasterCam.
They are "looking into it" but I'm wondering if this is just a limitation of the software. In FeatureCAM guides it mentions that I can use the thread chain, and the software will use the difference between X values at the start and end of the chain for the taper
Is this something that can be done in MC?
I'm manufacturing an auger for concrete using a standard lathe. I was able to make one with straight threads really well using a 08 button tool, but i'm struggling with this.
Thank you
