Dan from Oakland

todd goff · Jan 24, 2019

Hey Dan, don’t do anything on the gears boy have I screwed up on my figures. I think I’m just going to change the d.p. and tooth counts too for that matter. Sorry about that.

todd goff · Jan 24, 2019

Hey Dan, the 2 gears I need are 22 diametral pitch and 20 degree pressure angle. Tooth count is nothing major but I’ll need the o.d. Of the gear to be 1.750 with a say 7/8 hub if possible by 1” tall. It goes on a 14 mm shaft with a 5 mm keyway. If you want to call me my cell phone number is 803-210-6268 and I can explain it a little bit better and thanks in advance.

BELT_FED · Apr 17, 2015

Dan I've not received anything. Could you please try to resend it

Dan from Oakland · Apr 16, 2015

Brett- I sent a reply via e-mail- hopefully you received it a few days ago.
Dan

BELT_FED · Apr 14, 2015

I sent you a message to your email. Don't know if you have had time to check it. I've got a 4 axis mori seiki mv-jr with a "torque" problem. I saw where you said you thought your machine had "no balls" but found out it had a loose belt. If you have any info on this procedure or a part number on the belt itself if you replaced it. I'd be very appreciative of any info you have. I stalled trying to drill a 1/2" hole 1.375 deep in 316L @480 rpm and 1.7 ipm in a peck cycle.

Appreciate any help you can give

Thanks Brett

daleroe · Jun 7, 2013

Hello Dan,
I've been reading through some old posts regarding G-code for the Hurco BX control. In one post you offered a copy of the NC manual to another member. I would like to get a copy myself if your willing and still have it. I'll gladly pay for photocopies, shipping and whatever is needed. Thank you.
sine cera
dale

Search

Largest Manufacturing Technology Community on the Web

Search

Dan from Oakland

Find content

Profile posts Latest activity Postings About

todd goff

todd goff

BELT_FED

Dan from Oakland

BELT_FED

daleroe