Hobby Racer
Aluminum
- Joined
- Apr 18, 2015
It looks like the compound on my 1942 10EE is missing the screw nut retainer. Does anyone have a picture of what it should look like so I can source a suitable replacement?
Largest Manufacturing Technology Community on the Web
Stay Connected:
10EE Compound Screw Nut Retainer Missing
- Thread starter Hobby Racer
- Start date
- Replies 4
- Views 0
Cal Haines
Diamond
- Joined
- Sep 19, 2002
- Location
- Tucson, AZ
Mine has a button-head cap-screw and a washer, but I doubt it's original.
Hobby Racer
Aluminum
- Joined
- Apr 18, 2015
Yeah, I was going to go that route but then I noticed there is a taper in the nut below the surface of the compound. Monarch probably used some special fastener.
Cal Haines
Diamond
- Joined
- Sep 19, 2002
- Location
- Tucson, AZ
If you look at square-dial parts sheet 150, it's part EE-1444. So it is a custom part and a round-dial legacy part that survived into the square-dial era. Perhaps Monarch has them in stock for a reasonable price?
Hobby Racer
Aluminum
- Joined
- Apr 18, 2015
Well, when my lathe is up and running shortly, I can just make myself one. 
