What do you think is acceptable lathe bed wear on a Schaublin 125 ?
I have been looking at one wich i could measure 0.03mm wear on both thicknes and width
with micrometer .
For a used machine from the seventies I guess its not very bad ?
The machine is stripped down quite alot for cleaning by my friend so I cant try it out .
Thanks Johan
I have been looking at one wich i could measure 0.03mm wear on both thicknes and width
with micrometer .
For a used machine from the seventies I guess its not very bad ?
The machine is stripped down quite alot for cleaning by my friend so I cant try it out .
Thanks Johan
) in the beds. However, we still made them work, just couldn't do any real tight tolerance stuff. And we were always shimming the tailstocks to get the center height close enough.
