Rigging suggestions for Maho MH1000 manual mill

Frederick Harvie · Dec 14, 2022

I have a customer who has a MH1000 coming in on a flat bed and am looking for rigging suggestions foe unloading it. I can lift it with the boom on a
heavy recovery truck or possible slide it across onto a roll back truck. Are there recommended lifting points

k

Blazemaster · Dec 14, 2022

There should be a large hole in the side of that machine where you can put a bar through to the other side. The manual I have shows that as a lifting point.

jz79 · Dec 15, 2022

a picture is worth a thousand words

p.s. Z axis should be lowered on to blocks to avoid damage to thrust bearings or ballscrew when being transported, it may have built in jacks in the Z saddle, some Mikrons do, don't know about MAHOs

Frederick Harvie · Dec 17, 2022

What diameter is the hole and how long a bar is needed

L.Svedberg · Dec 17, 2022

On my mh700c the hole is 50mm and I used a bar around 1000mm long. Guess 600mm would have been enough. Not sure yours is the same, of course...

Search

Largest Manufacturing Technology Community on the Web

Search

Rigging suggestions for Maho MH1000 manual mill

Frederick Harvie

Stainless

Blazemaster

Hot Rolled

jz79

Stainless

Frederick Harvie

Stainless

L.Svedberg

Plastic

Similar threads