DMG DMU50evo spindle oil-air lubrication settings

blakelyj2 said:

Most Air Oil Spindle units that I see typically have 4 lines going into the spindle, so I am concerned that one of these is not present on your machine. Can you take a picture of the actually injection block for me? Trace those lines going back into a block that has the air and oil from the pump itself going into the block. That will help me see how many injectors their are.

Click to expand...

blakelyj2 said:

Most likely the air/oil coming out of the bottom is either serves a drain function or a positive air displacment funtion to prevent chips from entering the spindle if I had to guess. Each line is stamped as a 3, so your getting .03 cc of oil per shot when that block is activated. As for proper air pressure, it should be set up so that if you held a flashlight up to the clear lines you can see tiny droplets marching along the wall of the tube towards the spindle. Ideally, you want that lubricant shot to be divided up with the right amount of air to spread out the timing in between shots, so by the time the first shot of lubricant is running out, the next shot comes right in time to continue lubricating/cooling the spindle. Hope this helps.

Click to expand...