Alex22
Plastic
- Joined
- Mar 7, 2011
- Location
- Hartford Area
I cannot for the life of me find the tool change program on this machine with the Fanuc 0i-MD controller.
So far I've changed 3202 NE9 and PSR to allow for searching and editing of the 9xxx programs but still no luck. I have made and edited a 9xxx program but that is the only one that will show up in the directory. I've also seen reference to parameter 10 bit 4 but this controller does not have that bit labeled as mentioned in a few other threads on here have suggested.
I vaguely remember a former maintenance tech say that the tool change was done through the ladder only without its own program.
Have any of you run into this before?
-Alex
So far I've changed 3202 NE9 and PSR to allow for searching and editing of the 9xxx programs but still no luck. I have made and edited a 9xxx program but that is the only one that will show up in the directory. I've also seen reference to parameter 10 bit 4 but this controller does not have that bit labeled as mentioned in a few other threads on here have suggested.
I vaguely remember a former maintenance tech say that the tool change was done through the ladder only without its own program.
Have any of you run into this before?
-Alex
