Hello,
I'm having an issue (or a nuisance really) that I can't get cycle start when Y axis is not at home.
Sometimes when doing some manual stuff it would be really handy to be able to, i.e. when doing a MDI with a part-off tool that have a small Y adjustment to be on center line.
Is there any way to disable this check, or is there a reason for this requirement?
Thank you!
I'm having an issue (or a nuisance really) that I can't get cycle start when Y axis is not at home.
Sometimes when doing some manual stuff it would be really handy to be able to, i.e. when doing a MDI with a part-off tool that have a small Y adjustment to be on center line.
Is there any way to disable this check, or is there a reason for this requirement?
Thank you!
