Good morning!
Ill preface this by saying that I am not trying to hold +/-.00001" or even +/-.0002" on the Doosan DNM4500. I cant get into much detail on the application, but I am trying to determine if I can change the programming resolution (and display resolution) on this control to 5 decimal places. Again, this is not for a practical purpose, it is for experimentation. I have, in the past, managed to change the tool offsets to read 5 decimal places, but that is all I was able to achieve.
If anyone has any insight into this, it would be much appreciated.
Ill preface this by saying that I am not trying to hold +/-.00001" or even +/-.0002" on the Doosan DNM4500. I cant get into much detail on the application, but I am trying to determine if I can change the programming resolution (and display resolution) on this control to 5 decimal places. Again, this is not for a practical purpose, it is for experimentation. I have, in the past, managed to change the tool offsets to read 5 decimal places, but that is all I was able to achieve.
If anyone has any insight into this, it would be much appreciated.
