What's new
What's new

Shop Sink?

wilbilt

Hot Rolled
Joined
Feb 20, 2005
Location
Honcut, Ca. USA
What does everyone use for a cleanup area in a home shop?

I have a double-bowl "kitchen" sink I was planning to set up, but recently saw an old concrete mop sink that has me interested. It's probably very cheap.

Just wondering what you all do for handwashing, etc.

Will
 

wilbilt

Hot Rolled
Joined
Feb 20, 2005
Location
Honcut, Ca. USA
icehd81 ,

My problem exactly. SWMBO has a problem with that.

Home Deeper sells a cheap "laundry sink", but I worry about the plastic legs. I'm afraid I would break it. I already broke the kitchen sink... :rolleyes:
 

PeteM

Diamond
Joined
Jan 15, 2002
Location
West Coast, USA
Laundry sinks are about right if you're buying new. You want a deep tub and/or a high faucet. Having enough room to get a 5 gallon bucket underneath is about right IMO. I'd also suggest a faucet with hose threads.

Most cheap plastic laundry tubs have both wall mounts and leg mounts. My shop sink uses both -- and that's one way to allay your concern. You could also build a cabinet under the tub.

Les' solution -- to find a deep stainless sink is even better. Just more expensive, unless you find one used.

If it's a home shop and it has only cold water, I'd suggest adding a small capacity on-demand electric heater. Even a trickle of hot water comes in handy, and with the on-demand heater you're not paying to heat a tank of water you'll only be using now and then.
 

michael

Cast Iron
Joined
Oct 4, 2004
Location
hangtown, california
Les has it right. I have been using a stainless steel restaurant sink in my shop for years. Using a sprayer I can do a sit-down shower. Life would not be the same without that sink.
 

bigais

Stainless
Joined
Sep 29, 2003
Location
Etters Pa USA
You should be able to buy a two bowl stainless restaurant sink most reasonable as all restaurants are now required to have 3 bowls for dish washing purposes, at least in Pa.I had 3 nice two bowl and could only get $100.00 each.
 

steve-ma

Aluminum
Joined
Jun 8, 2005
Location
MAssachusetts
I wanted a stainless steel sink, but wound up settling for a laundry tub from the Home Despot. The one I have has metal legs, and the only complaint I have is that it stained up pretty quick, but I also haven't tried to clean it :rolleyes:

I can get a 5 gal pail under the faucet and that comes in handy at times. I have a cheapo kithcen faucet set with a sprayer. I also put one of those push down liquid soap dispensors that also comes in handy.
 

wilbilt

Hot Rolled
Joined
Feb 20, 2005
Location
Honcut, Ca. USA
You should be able to buy a two bowl stainless restaurant sink most reasonable as all restaurants are now required to have 3 bowls for dish washing purposes
I work for a school district, and they have to upgrade theirs, too. About 10 people have already laid clam to the old sinks, though.

They are too big for the corner I need to put mine in anyway, because they have big drainboards on each side.
 

Michael Az

Stainless
Joined
Dec 16, 2002
Location
Safford, Az., USA
The bathroom in my shop isn't big enough for one of the double sinks so I have a bathroom sink. Kind of small but I can at least wash my hands. A tall faucet is a must.
Michael
 

surplusjohn

Diamond
Joined
Apr 11, 2002
Location
Syracuse, NY USA
consider putting in a catch bucket, ie a drain that passes thru a 5 gallon removeable bucket to catch that sludge and other crap that you dump in your sink, I have seen these but don't have one.
 

Space

Cast Iron
Joined
Oct 29, 2001
Location
Columbus, Ne, U.S.A.
I have a laundry sink in the basement, can come right out back door of shop in to the basement. Only problem I have with it is the height off of the ground. I'm 6' plus a bit and bending over to wash stuff in the bottom of the sink will kill your lower back. If I had the room out in the shop I would go with a stainless steel resturant sink, but beggars aren't choosers. Mark
 
J

jfsmith

Guest
I have a door directly in to the the basement of the new house, so I will be putting a laundry sink in next to the door. This will be my mud room area. I also have a full bath 8 feet away.

The Garage is a different story, but maybe next year I will run water out to it and connect to the sewer, so I can have running water and a drain.

Jerry
 
Deep double basin soapstone laundry sink. Deep and big enough to take a (snug fit) bath in either side. They used to throw these out on renovation jobs in DC in the 70's and replace them with small plastic ones. I scarfed this one right up and have carried it with me through a couple moves. It's not pretty, but it sure is functional!

smt
 

Weirsdale George

Stainless
Joined
May 17, 2003
Location
Weirsdale, FL
I have a wall mount plastic laundry tub in my shop for the past seven years. It is mounted 8" higher than normal so I don't have to stoop over as far. (It is great for finding leaks in inner tubes!) My only complaint is that the plastic surface is porous and is hard to keep clean. Would love to find an old-fashioned galvanized steel laundry tub.
 

jim rozen

Diamond
Joined
Feb 26, 2004
Location
peekskill, NY
Visibile in the background of this photo is
the small stainless bar sink I installed in
my basement shop:

http://www.metalworking.com/RCM-gallery/files/Rozen,Jim/Nshop1.jpg

Space is tight, but I feel strongly that all
labs and shops should have a place to wash
ones hands, and a well-lit mirror for getting
something out of your eye. There's a shelf
alongside it (not visible) that holds the band
aids and whatnot so it functions as the first
aid station as well.

Jim
 

14tony

Hot Rolled
Joined
Jul 27, 2004
Location
Arroyo Seco, New Mexico
So, how many of you, when you have played to long and can't make it to the john just hang it in that deep sink ? I keep a gallon jug of clorox under my deep sink for those occasions. Seems like every time I do it wifey breezes through the door and catches me. I think she has some kind of radar working for her. I tell her it's a guy thing and she's just jealous cause she cant do it.
 








 
Top